Type 2 Outdoor Magazine, 3" Lining 72"x48"x48"

HOUSING exterior and doors are constructed of ¼ hot rolled steel plate

• Features laser cut tab & slot technology for consistent fit at weldment.
• Standard designed recessed door provides increased security versus a flat plate closure.
• The formed steel doors provide greater strength. Drip protection is standard.

SKIDS For ease of movement

LINING Interior is finished with optional thicknesses (minimum of 2 to 4) of hardwood lining with the first inner layer securely bolted in place; and the final build up is then covered with ½ plywood.

HINGES & HASPS

• The hinges are welded to the door and exterior of the magazine in compliance with the ATF directive.
• All hinges are greased and standard with zerk fittings.
• The hasps are protected with formed ¼ steel hoods that prevent sawing or lever action on the locks, hasps and staples per ATF construction guidelines.

VENTILATION The vent cover is a one piece laser cut of steel and then formed. On the interior, stand-off strips are placed over the liner to prevent the packing of explosives against the wall and obstructing ventilation.

MOVEMENT / POSITIONING To enable easy movement, each magazine has openings at the front and rear ends of the skids and lift rings are securely welded on the top for the attachment of chains or cables.

LIGHTNING PROTECTION A Grounding Kit is optional.

LOCKS BATF approved locks are available and can be keyed as required.

GENERAL All outdoor magazines are bullet-resistant, fire-resistant, theft-resistant and constructed to prevent direct contact with the ground